Having a pressure washer can be one of the most valuable pieces of equipment that you own, but if it stops working, you’ll need to take it in for power washer repair.
Damage to Your Pressure Washer
If you have a pressure washer, then you already know how amazing it can be to keep the space around your business clean. It has the ability to handle some of the toughest cleaning problems, including getting rid of dirt and grime on concrete, and it can also be used to keep other equipment looking amazing.
When something goes wrong with the machine, this can be incredibly frustrating. It may also mean that you have to take the machine in for pressure washer repair. There are some common problems that occur with pressure washers, including those listed below.
If you notice that your washer doesn’t have the same amount of water pressure that it used to have in the past, this could mean that your nozzle has worn out. Getting a new one can be beneficial. It’s important to make sure you have the right one, as the wrong one can also have an impact on how much pressure your machine generates.
If you’ve changed the nozzle and the wand seems to be in good shape, another issue might be that the RPM on the engine isn’t set correctly. There may also be an issue with the plunger or a belt may have worn out and broken. Taking the machine to get pressure washer repair in Toronto is a good way to figure out exactly what issue is causing your low-pressure problem.
This incredibly common problem usually happens when seals get worn out. There are many of these throughout the machine, so checking to make sure they are in good condition and getting them replaced if not is important. Leaks can also be caused by packing or plungers that get work out or beak. Seals can also be impacted by the weather, and they may expand or contract depending on how hot or cold it is in the area where you are using the washer.
More often than not, the reason your washer is running rough is that you are using hot water at the inlet. To ensure that it runs properly, use cold water. If this doesn’t solve the issue, then you may not be getting enough air into the inlet or there is mechanical damage to the crankcase. If the latter is the problem, it will need to be taken in for power washer repair to correct the problem.
The Washer Shuts Off
If this happens, it may be due to the fact that the machine ran out of gas or ran out of oil. It will shut off automatically so that it doesn’t get damaged beyond repair. Another reason it may have shut off is that the thermostat reached a certain threshold. Adding fluids to the machine or giving it a chance to cool down should help. If it doesn’t, it will need to be taken in to be looked at.
It Won’t Start
If you’re sure that your washer has fuel and oil in it, then you’ll need to check the primer pump. If it has an electric starter, you’ll need to ensure that the power supply is still attached to the starter and ensure that old fuses have been checked and replaced.
Getting it Repaired
Nothing in this world was meant to last forever, and at some point, you will probably experience some issues with your washer. When this happens, taking it to Roy Turk Industrial Sales for parts or pressure washer repair can get it back into running condition.